Pulley Quote Sheet

Fill out the form, below, to request a quote for your pulley.

Step 1 of 2

50%
  • Upload Your Drawing for Quote

    Please upload your drawing, sketch, bar napkin, etc.
  • Drop files here or
    Accepted file types: jpg, pdf, png, tiff, zip, gif, step, stp, igs, iges, sat, doc, xls, xlsx, docx.
  • or Configure Your Pulley

    Please fill in as much known information as possible.
  • If you cannot find the pitch you need, please leave blank and tell us the pitch needed in the Special Features/Notes field at the bottom of the form.
  • Select Tooth Count Required
  • Provide width of belt being used. Please specify inch or mm
  • Provide pulley face width desired, if belt width is unknown. Please specify inch or mm.
  • (!) = Premium Feature
  • Required Bore. Please specify inch or mm. For TL or QD bushings, please provide detail in "Special Features" field below.
  • If material or finish required is not listed, please provide your specifications in the Special Features field below.
  • Please specify any required features not already specified above: V-Guide, Bore for TL or QD Bushing, Bearings, Hub Dimensions, Welded Flanges, etc.